GSA Auctions Miscellaneous Update

MODULAR BUILDING WITH ADA RAMP 40 FT X 12 FT

03/09/2016 01:55 PM EST

CURRENT BID: $100    STATE: TX    NO. OF BIDDERS: 0     CLOSE TIME: 03-23-2016 12:55 PM CT.

MODULAR BUILDING WITH ADA RAMP 40 FT X 12 FT (HXYAAA6068E615) Modular building with divider wall and ADA access ramp known as AAFES Bldg 3. See attached fabrication drawings for details of the construction of this building. Approx dimensions are 40 ft long x 12 ft wide x 10 ft tall. Allied Modular Integra 400 Model purchased in 2007. Wall sections are 4 in thick with stucco embossed hardboard on the exterior and vinyl clad hardboard on the interior. Building has a 40 ft long x 12 ft wide x 8 in tall forkliftable steel base with tongue and groove plywood and 2 in x 3 in angle. Front door has 60 in tall x 20 in wide 3/16 tempered glass. Front windows are 48 in wide x 72 in high and are also 3/16 tempered glass. Building comes equipped with light switches and duplex plugs built into the raceways between the panels. Lighting consists of 2 ft x 4 ft T8 light fixtures with four tube capacity. Flooring is plywood decking covered in 12 in x 12 in Armstrong VCT tile. Building occupant added laminate flooring to the retail area but it is unknown if this is tongue and grove or glued down. The flooring in storage office area is the original VCT tile. This has slat walls in the retail section that were installed by the prior occupant. Building has 36 ft of gutter and 2 downspouts. Has an ADA steel access ramp with platform and handrails. Roof makeup is 18 gauge B Deck with 3/4" in plywood covered by granulated cap sheet. Has a three ton Bard Manufacturing HVAC unit mounted to the outside wall of the building. Has a single phase load center with 20 amp breakers with a total 125 amp capacity. Building has a divider wall inside separating retail space from office and storage. Retail space is 28 ft long and the office is 12 ft long. Inside furnishings have been removed. Picnic tables, vending machines, and outdoor trash bins are not included. All company specific retail signage has been removed. The buyer must provide all labor, tools, and equipment necessary to disassemble, remove, and load this building. AAFES cannot assist in the process or provide and equipment or tools. All utilities will be disconnected by AAFES however the successful bidder will be responsible for confirming utilities are disconnected prior to commencing with removal. All work must be accomplished in a safe manner and in compliance with any applicable codes or regulations. Any debris generated by the removal of this building will be the responsibility of the buyer and must be properly disposed of. Buyer will be responsible for any damage caused to the property that is not consistent with the removal of the building. HXYAAA6068E615